Contents | < Browse | Browse >
VOICESHELL v1.11 AVAILABLE FOR FTP
VoiceShell is a voice recognization utility. It allows
you to start commands just by saying the command into a
VoiceShell is a replacement for VCLI by Richard Horne.
It uses the voice.library also by Richard Horne.
VoiceShell, however, doesn't have a graphic display of
the spoken words and is thus faster that VCLI.
With VoiceShell you have full control over the supported
samplers, including the DSS 8+. You can now choose between
left/right input channels, microphone or line level, input
VoiceShell also has an ARexx port to allow almost full
control over VoiceShell from external programs. You can
even send ARexx by voice commands to VoiceShell itself,
allowing you to control VoiceShell with voice commands!
The program requires Kickstart 2.04 or higher. A sampler,
i.e. audio digitizer hardware, is of course needed. VoiceShell
supports Perfect Sound, Sound Master, GVP DSS 8(+) and generic
(i.e. almost any other digitizer) samplers. The voice.library
is also required and included in the archive so you won't have
to worry about this.
The documents are in AmigaGuide format, so in order to read
them you'll need an AmigaGuide reader.
There is an install script included, so you may use this to
install VoiceShell if you have the Commodore Installer program
on your system.
Available on Aminet FTP sites. Try 'wuarchive.wustl.edu'.
VoiceShell is shareware. The suggested shareware fee is
$5 - $10.
VoiceShell is shareware, (c) Copyright Tomi Blinnikka 1993.
The archive is freely distributable.
Support available direct from the author via EMail.